Instruction manual

Page 164
Totaliser
When Ultra Wizard = 3 Flow
P820 Totaliser
Displays the current value of the, non-resettable totaliser. During run mode
this totaliser can be viewed via the “Totaliser” hot key, . Unlike the
resettable totaliser this totaliser cannot be reset while in run mode, it can
however be reset while in program mode by accessing P820 Totaliser and
entering zero.
P821 Totaliser( R )
Displays the current value of the, resettable totaliser. This totaliser can be
allocated to appear, during run mode, on the auxiliary display line (P816)
or alternatively via the “Totaliser” hot key.
P822 Totaliser Decimal Places
This parameter determines the number of decimal places in the totaliser
during run mode. It can be set between 1 and 3. Default = 2
P823 Totaliser Multiplication Factor
Use this parameter if the totaliser increments by to large or small amount,
enter the factor by which the actual flow rate is multiplied by before
incrementing the totaliser .
E.g. if flowrate is being calculated and displayed in ltrs/second and it is
desired to increment the totaliser in cubic metres select 7 = *1000.
When viewing, the totaliser display will state, “Units are: L*1000”, and the
totaliser will be incremented every 1000 litres
Options are:
Option
Descrip
tion
1= 1/1000
(Default)
Totaliser will increment every 1/1000
th
units of flow
2= 1/100
Totaliser will increment every 1/100
th
units of flow
3= 1/10
Totaliser will increment every 1/10
th
units of flow
4= 1 (Default)
Totaliser will increment every 1 uni
ts of flow
5= 10
Totaliser will increment every 10 units of flow
6= 100
Totaliser will increment every 100 units of flow
7= 1,000
Totaliser will increment every 1000 units of flow
8= 10,000
Totaliser will increment every 10,000 units of flow
9= 100,00
0
Totaliser will increment every 100,000 units of flow
10= 1,000,000
Totaliser will increment every 1,000,000 units of flow