Instruction manual

Page 174
Backup
P925 Parameter Backup & Restore
This parameter is used to make a backup of all parameters, for example to
ensure a default set is maintained within the unit. If alterations are made to
the parameters that do not work as intended, then the backup set can be
restored into the unit.
You can make two separate backup copies if you wish, called backup 1 and
backup 2, and restore from either.
The options are:
Option
Description
1= Backup 1
Make backup to area 1 of
all parameters
2= Backup 2
Make backup to area 2 of all parameters
3= Restore 1
Restore all parameters from area 1
4= Restore 2
Restore all parameters from area 2
System Information
The following three parameters do not affect how the unit performs, but details,
contained in them, may be required, by Pulsar, when making technical
enquiries.
P926 Software Revision
This parameter will display the current software revision. It is read only, and
cannot be changed. The software revision can also be viewed while in
RUN mode by pressing the decimal point key.
P927 Hardware Revision
This parameter will display the current hardware revision. It is read only,
and cannot be changed.
P928 Serial Number
This parameter will display the serial number of the unit. It is read only, and
cannot be changed. The serial number can also be viewed while in RUN
mode by pressing the decimal point key.
P929 Site Identification
This parameter allows you to give each unit an individual reference number,
for identification purposes. You can set any number between 1 and 99999.