Service manual

Groundsmaster 3280−D/3320Page 1 − 4Safety
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service, use correct blocks, hoists
and jacks. Make sure machine is parked on a
solid level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and prop-
er raising of the machine. Always chock or
block wheels. Use jack stands or solid wood
blocks to support the raised machine. If the ma-
chine is not properly supported by blocks or
jack stands, the machine may move or fall,
which may result in personal injury.
Front End Jacking
1. Set parking brake and chock rear tires to prevent the
machine from moving.
2. Position jack securely under the frame (not the axle),
just to the inside of the front tire.
3. Jack front of machine off the ground.
4. Position jack stands or hardwood blocks under the
frame as close to the wheel as possible to support the
machine.
Rear End Jacking
1. Set parking brake and chock both front tires to pre-
vent the machine from moving.
2. Place jack securely under the frame (not the axle) di-
rectly in front of the rear axle.
3. Jack rear of machine off the ground.
4. Position jack stands or hardwood blocks under the
frame to support the machine.
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the traction unit and the cutting deck of the Grounds-
master. If any decal becomes illegible or damaged, in-
stall a new decal. Part numbers are listed in your Parts
Catalog. Order replacement decals from your Autho-
rized Toro Distributor.