Service manual

Groundsmaster 3280−D/3320 Page 7 − 19 Chassis

Removal (Fig. 9)

1. Park machine on a level surface, lower cutting deck

(or implement), stop engine, engage parking brake and

remove key from the ignition switch.

2. Remove seat and seat suspension from machine

(see Operator Seat in this section).

3. Remove mechanical seat suspension components

as needed using Figures 9 and 10 as guides.

Installation (Fig. 9)

1. Install mechanical seat suspension components us-

ing Figure 9 and 10 as guides.

2. Install seat and seat suspension to machine (see

Operator Seat in this section). Make sure to connect

electrical connector to the seat switch.

1. Suspension assembly

2. Mounting bracket

3. Cap screw (4 used)

4. RH slide bracket

5. Lock nut (4 used)

6. LH slide bracket

Figure 10

Chassis