Service manual

Groundsmaster 3280−D/3320 Page 7 − 21 Chassis

Removal (Fig. 11)

1. Park machine on a level surface, lower cutting deck

(or implement), stop engine, engage parking brake and

remove key from the ignition switch.

2. Remove seat and seat suspension from machine

(see Operator Seat Removal in this section).

3. Remove pneumatic seat suspension components as

necessary using Figures 11 and 12 as guides.

Installation (Fig. 11)

1. Install pneumatic seat suspension components us-

ing Figures 11 and 12 as guides. Refer to Figure 11 for

fastener torque values for assembly purposes.

2. Install seat and seat suspension to machine (see

Operator Seat Installation in this section). Make sure to

connect electrical connector to the seat switch.

1. Suspension assembly

2. Bracket (2 used)

3. Cap screw (4 used)

Figure 12

Chassis