Service manual

Groundsmaster 3280−D/3320Page 8 − 52Drive Axles
Bidirectional Clutch Service (4 Wheel Drive)
1. End plate
2. Socket head screw (6 used)
3. Oil seal
4. Snap ring
5. Bearing
6. Housing
7. Phillips head screw w/o−ring
8. Hub
9. Needle bearing
10. Thrust washer
11. Wave spring
12. Roller cage assembly
13. Oil seal
14. Bearing Housing
15. Bearing
16. Snap ring
17. Retaining ring
18. Oil seal
Figure 95
7
3
4
5
1
6
8
2
9
10
11
14
15
12
13
16
17
18
14 ft−lb
(19 N−m)
Hylomar Jointing
Compound
REAR
DRIVE
SHAFT
AXLE
Disassembly (Fig. 95)
1. Thoroughly clean exterior of clutch before disassem-
bly.
2. Disassemble clutch using Figure 95 as a guide.
Assembly (Fig. 95)
1. Lightly lubricate clutch components with clean Mobil
Fluid 424 before assembly.
2. Assemble clutch using Figure 95 as a guide.
3. When installing oil seals, make sure that seal lips are
facing in.
4. Apply Hylomar Jointing Compound (or equivalent) to
end plate (item 1) mating surface before installing end
plate.
5. Secure end plate with six (6) socket head cap
screws. Torque screws 14 ft−lb (19 N−m).