Service manual

Groundsmaster 3280−D/3320Page 9 − 4P.T.O. System
P.T.O. Drive Shaft
1. P.T.O. shaft
2. End yoke
3. Lock nut (2 used per end yoke)
4. Grease fitting
5. Slip shaft yoke
6. U−joint kit (cross and bearings)
7. Flat washer (2 used)
8. Gearbox bracket (2 used)
9. Cutting deck gearbox
10. End yoke
11. Roll pin
12. Cap screw (2 used per end yoke)
13. Slip tube yoke
14. Cotter pin
Figure 2
FRONT
RIGHT
9
1
12
14
6
5
4
13
2
10
3
11
7
8
3
12
6
Do not start the engine and engage the P.T.O.
switch when the P.T.O. drive shaft is discon-
nected from the cutting deck (or implement). If
the engine is started and the P.T.O. shaft is al-
lowed to rotate, serious personal injury and
machine damage could result. Disconnect the
P.T.O. electric clutch electrical connector
whenever the P.T.O. drive shaft is discon-
nected from the cutting deck (or implement).
WARNING