Service manual

Groundsmaster 3280−D/3320Cutting Units
Page 10 − 16
Cutting Deck Rollers and Skids
1. Cutting deck
2. Carriage screw
3. Flange nut
4. LH skid
5. Cap screw
6. Roller spacer
7. Roller
8. Flange nut
9. Lock nut
10. Roller (2 used)
11. Cap screw
12. Roller
13. Roller shaft
14. Flange head screw
15. RH skid
Figure 13
FRONT
RIGHT
2
7
4
5
1
14
13
10
12
11
9
6
8
3
33
2
15
Removal (Fig. 13)
1. Remove skids and rollers from cutting deck using
Figure 13 as a guide.
Installation (Fig. 13)
1. Install skids to cutting deck using Figure 13 as a
guide. Make sure to install skids in the same mounting
hole height position (lower or upper).
2. When installing rollers to deck, tighten nut until roller
will not rotate, then loosen nut only enough to allow roller
to rotate freely. Make sure to install all cutting deck roll-
ers in the same mounting hole height position (lower or
upper).