Service manual

Groundsmaster 3320Page 3 − 12Gasoline Engine
Engine
Figure 11
1. Engine
2. Muffler bracket
3. Lock washer
4. Negative battery cable
5. Flat washer
6. Cap screw
7. Flange head screw
8. Flange nut
9. Muffler gasket
10. Muffler
11. Hex nut (4 used)
12. Frame trim
13. Spacer
14. Cap screw (2 used per mount)
15. Engine shock mount (red patch)
16. Air cleaner mounting bracket
17. Lock nut (3 used)
18. Flat washer (3 used)
19. Engine shock mount (3 used)
20. Engine mount bracket
21. Spacer (4 used)
22. Rebound washer (4 used)
23. Cap screw (4 used)
24. Lock nut (2 used per mount)
25. Lock washer (2 used per mount)
26. Cap screw (2 used per mount)
27. Lock washer (1 used)
28. Engine mount bracket
FRONT
RIGHT
9
5
26
2
23
24
4
3
22
1
10
20
28
19
8
16
7
25
6
21
15
14
13
11
12
17
27
18
5
14
20
24
23
22
21
26
25
50 to 60 ft−lb
(68 to 81 N−m)
50 to 60 ft−lb
(68 to 81 N−m)
Removal (Fig. 11)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine and remove key from the
ignition switch. Chock wheels to keep the machine from
moving.
2. Open hood (see Traction Unit Operator’s Manual).
3. Disconnect negative (−) and then positive (+) battery
cables at the battery.
4. Remove battery from machine (see Battery Service
in the Service and Repairs section of Chapter 6 − Electri-
cal System).