User guide

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B 27
Kit Operation
11.The LEDs can also be renamed, as shown in Figure 3-17.
Figure 3-17. Rename LEDs
12.Generate the configuration file by clicking the Generate Configuration File icon on the tool
bar or by pressing [Ctrl] + [G]. The status of configuration file generation is shown in the status
bar at the bottom of the EZ-Click window (see Figure 3-18).
Figure 3-18. EZ-Click Status Bar Showing Configuration Generation Status
13.Click the Apply Current Configuration icon on the tool bar in the EZ-Click 2.0 customizer tool
or press [Ctrl] + [L] to download the generated configuration to the MBR3 device.
14.Wait for the message “Device configuration completed successfully” to be displayed on the status
bar, as illustrated in Figure 3-19.
Figure 3-19. EZ-Click Status Bar Showing Successful Device Configuration
15.Touch the buttons on the kit to observe the features as enabled in the configuration.
Note: The Water Tolerance configuration file is preloaded into the kit. The kit supports the features
mentioned in Water Tolerance on page 58 by default. To learn more about the configurations, see
Configuration Files on page 51.