User guide

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B 63
Configuration Files and Example Projects
Figure 5-21. Jumper Location on the Kit
Two example projects showcase how to configure the MBR3 device and how to communicate with
the device. To open these projects, you need PSoC Creator 3.0 or later. Download and install the
software from www.cypress.com/PSoCCreator, if required.
To verify these projects, you need a PSoC 4 Pioneer Kit.
See Running Configuration Files and Host Projects on page 51 for information on how to access the
example projects.
5.3.1 Host_LED_Toggle_Buzzer_PSoC4_Pioneer_Kit
5.3.1.1 Project Description
This example project uses PSoC 4 as the I
2
C master (host) to configure the CY8CMBR3116 device.
This project shows how to write data to the CY8CMBR3116 device using I
2
C communication lines.
In this project, PSoC 4 loads the 128-byte configuration data to the MBR3 device using I
2
C commu-
nication. The 128-byte configuration data of the LED Toggle configuration is sent to the MBR3
device.
This project can be used to learn the process of configuring the device using an external host. See
Configuring the MBR3 Device From the PSoC 4 Pioneer Kit on page 72 for details