User guide

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B 9
Introduction
1.3 Factory Default Configuration
The kit installation folder includes three configuration files that demonstrate several features of the
CY8CMBR3116 CapSense controller. The section, Configuration Files on page 51, provides more
details. The CY3280-MBR3 EVK is configured with the Water Tolerance configuration by default. In
this configuration, water tolerance, flanking sensor suppression (FSS), and auto-reset features are
enabled for four CapSense buttons. The LEDs are also enabled to provide visual feedback for
CapSense button touch. For more details on configuring the MBR3 device, refer to the EZ-Click 2.0
Customizer Tool User Guide, available at <Install_Directory>\EZ-Click\<version>\Doc-
umentation.
1.4 Additional Learning Resources
Visit the CY8CMBR3116 CapSense Controller page for additional learning resources.
1.5 Technical Support
For assistance, go to our support web page, or contact our customer support at [phone]
extension 2 (in the USA), or [phone] extension 2 (International).
1.6 Acronyms
Table 1-1. Acronyms Used in the Document
Acronyms Definition
BCP Bridge Control Panel
BOM bill of materials
CS capacitive sensor
CSD CapSense sigma delta
ESD electrostatic discharge
EVK evaluation kit
FSS flanking sensor suppression
GPO general-purpose output
GUI graphical user interface
IIC/I
2
C
inter-integrated circuit
LED light-emitting diode
MBR mechanical button replacement
NC not connected
PC personal computer
PCB printed circuit board
PSoC
®
Programmable System-On-Chip
SNR signal-to-noise ratio
UART universal asynchronous receiver/transmitter
USB universal serial bus