- Applicated Security Technologies Automobile Alarm User Manual

Entering Program Mode

1) With the ignition in the OFF position, turn the ignition key from “Off” to “On” 3 times,

ON-OFF-ON-OFF-ON within three seconds. (Leave the key in the ON position)

2) Press and release the Program Button located on the antenna. The park lights will

flash and the siren will chirp to confirm entering program mode.

3) Select desired Program Menu (See below). The park lights will flash and siren

will chirp to confirm the selected menu.

4) Select Programmable Setting:

a) Press and release the Program Button the correct number of times to select the

desired Program Setting. The park lights and LEDs will flash and the siren

will chirp to indicate the Program Setting that has been selected. For example:

1 flash/chirp= Program Setting 1; 2 flashes/chirps= Program Setting 2; etc…

b) Press and Hold the Program Button until the park lights flash and the horn(optional)

chirps to confirm the desired setting. For example: 1 flash/chirp= Setting 1;

2 flashes/chirps= Setting 2; 3 flashes/chirps= Setting 3.

c) Turning the ignition key to the “Off” position or 30 seconds of no activity will exit

Program Mode. This will be confirmed with a light flash and a long siren chirp.

The Program Menu may be changed at any time by pressing the transmitter

button (below), this will allow the installer to jump from one menu, then quickly jump

to another menu and change another setting without re-entering Program Mode.

Note: If unit does not enter Program mode, turn ignition off for 5 seconds and repeat

steps 1-4.

Program Menus

Menu 1: User Settings- Press Lock (Button#1) Page 16-17

This program menu is for the adjustments for the user and door lock options.

Menu 2: Additional Settings- Press Unlock (Button #2) Page 17-18

This program menu is for additional settings.

Menu 3: Starter Settings- Press Start (Button #3) Page 18-19

This program menu is for various remote car starter applications.

Menu 4: Tach Settings (Button #4) Page 20

This program menu is for tach signal adjustments.

Page 14

INSTALLATION MANUAL 2WAY REMOTE STARTER/ALARM

Ignition 3x

On/Off

On/Off On

Press and

Release

Press button

1 for Menu 1

Press button

2 for Menu 2

Press button

3 for Menu 3

Press button

4 for Menu 4