Technical information

562600-000, Issue1.0, March 2014
18 of 57
7.7 Lift Mode Menu
The Lifting Mode menu has various features which may be available if config-
ured at installation. If only one lifting point has been calibrated, the lifting
point button will not be displayed.
7.7.1 Lifting Point Selection
PMERail can be configured for more than one lifting
point. If more than one lifting point has been cali-
brated, they will be manually selected via the lifting
point selection screen shown below. Use the arrow
buttons to select the required lifting point and con-
firm using the GREEN TICK button. The Supervisor keyswitch must be in the SET posi-
tion to access this feature, see section 5.5 for further information. Example lifting points
are shown in the listing. Always refer to the manufacturer/convertor instructions regarding
positioning of the lifting point during lifting operations. Altering the lifting point will not af-
fect the current duty selected, see Appendix 1.
Moves highlighter UP
Moves highlighter DOWN
Accept highlighted
lifting point
Exit to previous screen
Exit without change
Displays load chart(s)
Lifting point selection
Lift Mode selection
Lifting point Height
and Radius
Lifting point Name