Specifications

9-2 Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
FIGURE 9-1 TTY Serial Port A on the Clock+ Board
3. Power on the terminal.
4. Set up the terminal.
Refer to the OpenBoot Command Reference for instructions for using the
set-defaults and printenv commands.
The settings will vary with the terminal type, but these settings are often used:
■ 9600 bps
■ 8 data bits
■ 1 stop bit
■ Even parity
■ Full duplex
5. Turn the key switch to the diagnostic position ( ).
The system will turn on. The diagnostic position puts POST in interactive mode and
enables extensive POST tests.
TTY Serial Port A
Rear view