Specifications

4-28 Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
2. Remove the GBIC from the I/O+ board by compressing the locking tabs located
on either side of the card and pulling straight out from the opening in the I/O+
board panel (
FIGURE 4-25).
FIGURE 4-25 Removing or Installing a GBIC
4.5.6.2 Installing a GBIC
1. Locate the GBIC slot for installation (FIGURE 4-24).
2. Ensure correct orientation for insertion.
The alignment slots should be on the bottom of the GBIC (
FIGURE 4-25).
3. Insert the GBIC into the I/O+ board panel slot and then push in to firmly seat the
card.
An audible click indicates the GBIC is properly seated to the onboard connector.
Alignment slot