User`s guide

- 22 -
6.1 Indicator lights No. 1, 2 and 3
Item UPS status
Lights condition
Audible alarm
12 3
1Normal lit no alarmsound
2Blackout blink
3Battery replacement warning lit
4Low battery blink
5Overload blink
6Overload shutdown or output lit
short circuit
7Stabilizer and charger test blink no alarmsound
8Backup and battery test blink no alarmsound
(After test, if the UPS
detected something
abnormal, a long
beep indicates.
To mute the alarm,
press the multi-
function switch.
9Easy-Mon X software send slow -
command for shutdown the blink
UPS.
10 UPS is shutdown and waiting slow -
for restart itself. blink
Under normal operating mode
During self-test
Schedule shutdown and restart
- 23 -
6.2 The meaning of LED display
6.2.1 Input voltage level and Load level display mode
6.2.1.1 lndicator lights no. 4 to no. 7 show how much power your loads are
consuming compared to the UPS capacity. Each lamps represents 25%
of UPS capacity.
- Lamp no.4 is lit when loads are above 8% and less than 25%.
- Lamp no. 4 and 5 are lit when load are between 26% to 50%.
- Lamp no. 4, 5 and 6 are lit when load are between 51% to 75%.
- Lamp no. 4, 5, 6 and 7 are lit when loads are between 76% to100%
- Lamp no. 4, 5 and 6 are lit and lamp no.7 is blink when loads are
over 100 % and you should reduce the load immediately.
6.2.1.2 Indicator lights no. 8, 9, 10 and 11 show input utility line voltage level.
- Lamp no. 8 is blink twice every 1.5 second when input voltage is
between 220 V - 30% to 220 V - 21% (154 V- 174 V).
- Lamp no. 9 is lit when input voltage is between 220 V - 20% to
220 V - 11% (175 V - 196 V)
- Lamp no. 10 is lit when input voltage is between 220 V - 10% to
220 V + 10% (197 V - 242 V)
- Lamp no. 11 is blink twice every 1.5 second when input voltage is
between 220 V + 11% to 220 V + 20% (243 V- 264 V).
Note: 1. The input voltage range above is the approximately values.
2. The lamp no.1 and no.8 are blink twice every 1.5 second
and alarm sound beep when blackout.
6.2.2 Battery level display mode
I ndicator lights no. 4 to no. 11 show battery voltage from low (lamp no. 4) to
high level (lamp no.11).
- Charging battery : the light up lamp show battery voltage at that
time. When the battery level is full, the indicator lights are all lit.
- Supplying backup power : the blinking lamp show the battery
voltage at that time. After supply power for a while, the next lamp
will blink because the power runs out.