Specifications

Elite Series Technical Manual PDL Part No. 4201-180 Rev J
47
STATUS LINE
AA STATUS LINE
Screen AA OFF 0.0% 0.0%
STP t+000% S+000%
Description STATUS, OVERLOAD, TORQUE/
CURRENT, SPEED, INDICATION
Units % OF RATED MOTOR TORQUE/AMPS,
% OF RATED MOTOR SPEED
Notes ALWAYS DISPLAYED
FUNCTION This is the top line of the display and is
permanently present. The status line shows
Elite Series status, overload condition,
output torque or current and output speed.
Indication of operational mode is also
provided.
SCREEN OFF 0.0% 0.0%
STP () t +000% S +000%
1234 56
Table Reference 1 2 3 4 5 6
REF. FUNCTION
1 Elite Series Status Indication
Refer to list opposite
2 Overload Status
Indicated by a lower case letter while
overload is present
i - current exceeds Elite Series rating.
The Elite Series will shut down to protect
itself if the overload persists.
m - current exceeds motor capability. The
thermal model of the motor indicates the
motor will become too hot if this condition
persists. The Elite Series will eventually trip
if the overload is not eliminated.
o - Elite Series and motor overload exists.
3 Torque Mode Indicator
T- Elite Series is in C/L vector torque
mode
t- Elite Series is in C/L vector speed
mode
I Elite Series is in VHz speed mode
or O/L mode
4 Motor Torque or Current Indication
In C/L vector mode this shows the actual
motor torque as a percentage of rated motor
torque. In V/Hz or O/L mode the motor
current is displayed in amps.
5 Speed Mode Indicator
S - Elite Series is in speed mode
s - Elite Series is in torque mode
6 Motor Speed Indication
Shows actual motor speed as a percentage
of rated motor speed
Status Messages
Indication STP
Message STOPPED
Notes Motor stopped.
Indication SPG
Message STOPPING
Notes Motor is stopping.
Indication RDY
Message READY
Notes Elite Series is ready to run. A start command
has been received but the bus voltage is too
low to run or L14 run at minimum speed is set
to NO and setpoint is below minimum speed
(L2).
Indication RUN
Message RUNNING
Notes Motor is running.
Indication INC
Message INCHING
Notes Elite Series is responding to an inch
command.
Indication ILT
Message CURRENT LIMITING
Notes Elite Series has altered the motor speed to
maintain the motor current at or below the
current limit setting.
Indication VLT
Message VOLTAGE LIMITING
Notes Elite Series is limiting the deceleration rate to
avoid excessive regeneration (Vdc > 720V).
Indication Fnn
Message FAULT TRIP
Notes Elite Series has tripped on a fault. Where
“nn” indicates the fault number (refer to
Screen F for detail).
Indication OFF
Message OUTPUT OFF
Notes Elite Series has switched off all output power.
Indication SLT
Message SPEED LIMITING
Notes Speed is being limited to value set by
Screens L1 or L2.
Indication TLT
Message TORQUE LIMITING
Notes Torque is being limited to value set by
Screens L3 or L4 or L8.
Indication ATU
Message AUTOTUNING
Notes Autotune in progress.
Indication SPN
Message SPIN STARTING
Notes Elite Series is searching for the speed of the
motor.
Indication HGT
Message HEATING
Notes DC Heat is being applied to the motor.
Indication LFX
Message LOW FLUX STATUS
Notes Open loop vector controller has detected that
the motor is close to stalling and has taken
compensatory action.