Datasheet
Table Of Contents
- 1. General Description
- 2. Electrical Characteristics
- 3. SX1272/73 Features
- 4. SX1272/73 Digital Electronics
- 4.1. The LoRaTM Modem
- 4.2. FSK/OOK Modem
- 4.2.1. Bit Rate Setting
- 4.2.2. FSK/OOK Transmission
- 4.2.3. FSK/OOK Reception
- 4.2.4. Operating Modes in FSK/OOK Mode
- 4.2.5. General Overview
- 4.2.6. Startup Times
- 4.2.7. Receiver Startup Options
- 4.2.8. Receiver Restart Methods
- 4.2.9. Top Level Sequencer
- 4.2.10. Data Processing in FSK/OOK Mode
- 4.2.11. FIFO
- 4.2.12. Digital IO Pins Mapping
- 4.2.13. Continuous Mode
- 4.2.14. Packet Mode
- 4.2.15. io-homecontrol® Compatibility Mode
- 4.3. SPI Interface
- 5. SX1272/73 Analog & RF Frontend Electronics
- 6. Description of the Registers
- 7. Application Information
- 8. Packaging Information
- 9. Revision History
www.semtech.comPage 46
SX1272/73
WIRELESS, SENSING & TIMING DATASHEET
Rev. 2 - July 2014
©2014 Semtech Corporation
The default settings of the OOK demodulator lead to the performance stated in the electrical specification. However, in
applications in which sudden received signal power reduction is possible, the three parameters should be optimized
accordingly.
Optimizing the Floor Threshold
OokFixedThresh determines the sensitivity of the OOK receiver, as it sets the comparison threshold for weak input signals
(i.e. those close to the noise floor). Significant sensitivity improvements can be generated if configured correctly.
Note that the noise floor of the receiver at the demodulator input depends on:
The noise figure of the receiver.
The gain of the receive chain from antenna to base band.
The matching - including SAW filter if any.
The bandwidth of the channel filters.
It is therefore important to note that the setting of OokFixedThresh will be application dependant. The following procedure
is recommended to optimize OokFixedThresh.
Figure 16. Floor Threshold Optimization
The new floor threshold value found during this test should be used for OOK reception with those receiver settings.
Optimizing OOK Demodulator for Fast Fading Signals
A sudden drop in signal strength can cause the bit error rate to increase. For applications where the expected signal drop
can be estimated, the following OOK demodulator parameters OokPeakThreshStep and OokPeakThreshDec can be
optimized as described below for a given number of threshold decrements per bit. Refer to RegOokPeak to access those
settings.
Set SX1272/3 in OOK Rx mode
Adjust Bit Rate, Channel filter BW
Default OokFixedThresh setting
No input signal
Continuous Mode
Optimization complete
Glitch activity
on DATA ?
Monitor DIO2/DATA pin
Increment
OokFixedThresh