REV.2007.11.
Car Finder and Auxiliary 1 are not available on 2way models.
PRESS & RELEASE ARM SYSTEM / LOCK DOORS
Timer Mode will start the vehicle at a user selectable start interval. The vehicle can be set to start once every 2, 3 or 4 hours, for a maximum of 12 starts. The vehicle will start at the selected start interval and run for the programmed runtime*. EXAMPLE: If the 4 hour start cycle was selected, the vehicle will start once every 4 hours and run for the programmed runtime*. Press and Hold for 3 seconds or until the park lights turn on. While the park lights are on the start cycle may be selected.
SHOCK SENSOR ADJUSTMENTS 1 - ENTER SHOCK SENSOR ADJUSTMENT MODE + Press & HOLD Lock + Unlock buttons at the same time Continue to hold for 3-5 seconds Until Siren Chirps 3 times 3 CHIRPS (Note: System will Arm or Disarm via silent arming prior to entering adjustment mode) 2 - ADJUSTING SENSOR Each time the lock button is pressed and released the sensitivity will be INCREASED by 1 level.
80 SERIES PAGE 18 OWNER'S MANUAL SYSTEM PROGRAMMING SHOCK SENSOR - Menu 1 LED 2way utilizes a bright blue light (LED) below the button that illuminates the button pad shortly after the button is pressed. The transmitter will also “beep” as an audible confirmation of the function. LOCK BUTTON When the lock button is pressed the light behind the button will flash once and the remote will beep once as confirmation that the function has been completed.
PAGE 19 DIAGNOSTICS SYSTEM PROGRAMMING - Menu 1 80 SERIES OWNER'S MANUAL RUN TIMER- This icon indicates the amount of time that the remote starter will run. The timer counts down in 2 minute increments EXHAUST and WHEEL’S- When the remote start is activated the remote will play a tune then turn on the remote start icons such as spinning tires, exhaust, key symbol and park light flash. Press the # button at any time to refresh the status.
80 SERIES OWNER'S MANUAL PAGE 20 SYSTEM PROGRAMMING SHOCK SENSOR - Menu 1 The ANTENNA icon indicates the signal strength between the remote and the vehicle. If the vehicle is out of operating range when a button is pressed the ANTENNA icon will disappear from the LCD. The KEY icon is displayed on the top of the LCD when the remote starter is activated. When the runtime expires this icon will turn off.
80 SERIES PAGE 21 REMOTE SETTINGS SYSTEM PROGRAMMING - Menu 1 OWNER'S MANUAL SETTING THE TIME (LCD 2way MODELS) To set the time on LCD 2way models, press and hold the and buttons until the remote transmitter chimes and the minute portion of the clock begins to flash. To change from minutes to hours, press and release the button. To increase the minutes or hours, press and release the button. To decrease the minutes or hours, press and release the button.
80 SERIES PAGE 22 OWNER'S MANUAL SYSTEMDIAGNOSTICS PROGRAMMING - Menu 1 ALARM STATUS / DIAGNOSTICS Diagnostic Mode is a tool that can help trouble shoot a start fault. If the remote starter fails to start i.e.: the hood is open the park likes will flash a diagnostic code. i.e.: 5 flashes = start attempt with hood open. If the vehicle does not remote start, count the park light flashes then compare it to the chart below.
PAGE 23 PRODUCT WARRANTY SYSTEM PROGRAMMING - Menu 1 80 SERIES OWNER'S MANUAL WARRANTY Applicated Security Technologies, Inc.
80 SERIES PAGE 24 OWNER'S MANUAL Technical Support: support@ultrastarters.com Additional Product Information: www.ultrastarters.com IMPORTANT NOTES LOCK, UNLOCK, DRIVER'S DOOR PRIORITY UNLOCK, TRUNK RELEASE AND THE AUXILIARY OUTPUTS ARE OPTIONAL OUTPUTS. ENABLING THESE FEATURES REQUIRES CUSTOM INSTALLATION & PROGRAMMING. THESE FEATURES MAY NOT BE COMPATIBLE WITH SOME VEHICLES. FOR SAFETY REASONS THE TRUNK RELEASE OUTPUT WILL NOT ACTIVATE WHEN THE IGNITION IS IN THE ON POSITION.
