Installation Manual MCS-100 Remote Control Motorcycle Alarm ! ! " #$ %
MCS-100 SECTION 1: SYSTEM LAYOUT 7 8 5 6 3 1 4 2 8 White Light Output (+20 Amp) Park or Signal Light (Diag. #4) 7 Red 15 Amp Fuse +12V DC Power 6 White Light Output (+20 Amp) Park or Signal Light (Diag. #4) 5 Black Ground Connect to Battery Ground 4 Green - Trigger Input (-) Tilt Switch or Sensor (Diag. #1) 3 Yellow Ignition Input (+) Ignition Wire (Diag. #3) 2 Brown LED Output (+3V) 3V LED (+) Wire (Diag. #2) 1 Orange Starter Interrupt Output (+) Start Wire (Diag.
MCS-100 2. Use 30/40 Amp SPDT relay to connect as shown. Connect the Starter Interrupt output (Orange) wire to pin 86 of the relay. Connect pin 30 of the relay to the Motor side of the Starter wire. Connect pin 87a of the relay to the switch side of the Starter wire. 3. Locate the Ignition wire. 4. Connect the Switched ignition (yellow) wire and 85 of the Starter Interrupt relay to the Ignition wire.
MCS-100 SECTION 3: SYSTEM OPERATION The MCS-100 is very sophisticated, but the operation is simple. Your two button RF transmitter is easy to use for arm, disarm, personal protection, and programming the system for many custom functions. 3.1 Remote System Arm (On) Press and release RF transmitter button #1. One siren chirp sound and a light flash verify the operation. If you hear four chirp sounds, the MCS-100 has detected a faulty sensor. 3.
MCS-100 Shock Sensor Disable Shock Sensor Enable (4.6) Valet Mode On Valet Mode Off (4.7) Audible Warning Sound Off Audible Warning Sound On (4.8) Siren Output Tone Selection (4.9) Shock Sensitivity Level Selection (4.10) Turn ignition on. Within 10 seconds, press button #1, #2, #3, #1 in succession. (#3=#1+#2) Turn Ignition on. Within 10 seconds, press button #2, #3, #2, #3 in succession. (#3=#1+#2) Turn Ignition on. Within 10 seconds, press button #1, #3, #2, #1 in succession.
MCS-100 4.4 Emergency Disarm The emergency disarm is activated through the ignition key switch and means that the system can be disarmed without remote. To activate the EMERGENCY DISARM: While the system is triggered, turn the ignition key on and off four (4) times within ten (10) seconds. The operation is confirmed with two siren chirp sounds and two parking light flashes.
MCS-100 4.7 Valet Mode The Valet Mode is activated through the ignition key switch and means that all normal system functions are turned off. This feature is useful when valet parking, refueling, or servicing your motorcycle. To activate the VALET MODE: Turn the ignition key to the on position. Within ten (10) seconds PRESS BUTTONS #2, #3, #2, #3 in succession. (#3=#1+#2) The valet mode is confirmed with one chirp sound and one parking light flash.
MCS-100 1. 2. 3. 4. 5. Turn the ignition key to the on position. Within ten (10) seconds PRESS BUTTONS #1, #3, #1, #3 in succession. (#3=#1+#2) The operation is confirmed with one chirp sound and one parking light flash. Press button #1 of your transmitter to increase the shock sensor sensitivity. If you want to increase more than one level of sensitivity, press and hold button #1 of your transmitter. You will hear 1 chirp sound every 1 seconds.
