Instruction manual

Step 15. Install the wing back onto the fuselage and gently

snug the wing bolts, securing the wing to the fuselage. Mark the

wing bolt plate location on top of the wing. Remove the wing

bolts and plate from the wing.

Step 16. Using a hobby knife, carefully trim away the covering

on the wing just inside the lines you marked for the wing bolt

plate. Be sure to avoid cutting into the balsa wood.

Step 17. Mix approximately 1/4 ounce of 6-minute epoxy and

glue the wing hold-down plate onto the wing. Wipe off any

excess epoxy and remove any epoxy from the wing bolt holes.

Allow the epoxy to completely cure before proceeding.

Section 4: Bolting the Wing to the Fuselage

CONTINUED