Instruction manual

Step 6. Mix approximately 1/4 ounce (minimum) of 30-minute

epoxy and apply it to the vertical stabilizer where it comes into

contact with the fuselage. Also apply epoxy to the base of the

vertical stabilizer where it comes in contact with the horizontal

stabilizer.

Important: It is essential that the vertical stabilizer base be

epoxied to the horizontal stabilizer inside the

fuselage to provide adequate strength. Be sure

to use plenty of epoxy.

Step 7. Insert the fin into the fuselage and wipe away any

excess epoxy using a paper towel and rubbing alcohol.

Step 8. Using a 90-degree triangle, make sure the fin is

perpendicular to the horizontal stabilizer. Use masking tape

to hold the vertical stabilizer in place until the epoxy cures.

Section 6: Installing the Vertical Stabilizer (Fin)

CONTINUED