Instruction manual

42
Section 14: Installing the Aileron and/or Quad Flap Linkages
Step 9. Remove the clevis from the control horn. Attach a wire
keeper to the end of the rod with the 90-degree bend.
Step 10. Insert the 90-degree bend through the second hole
from the end of the servo arm and install the end of the wire
keeper over the end of the wire. Install the clevis back onto the
control horn. Be sure to slide on the silicon clevis keeper onto
the end of the clevis.
Step 11. Repeat the process for the remainder of aileron/flaps
linkages.
CONTINUED