Instruction manual

Section 15: Installing the Rudder, Elevator, and Throttle Pushrods

Step 5. Remove the clevis and slide the pushrod wire out of the

guide tube. Make a 90-degree bend in the rod at the location

you just marked and cut off the rod leaving 1/4" extend out from

the 90-degree bend.

Step 6. Attach a wire keeper to the end of the rod with the

90-degree bend you just made.

Step 7. Insert the threaded end of the pushrod wire through the

wire guide tube from the wing saddle opening of the fuselage.

Install the 90-degree bend through the second hole from the end

of the servo arm and install the end of the wire keeper over the

end of the wire. Install the clevis back onto the pushrod wire and

connect it to the control horn. Be sure to slide on the silicon

clevis keeper onto the end of the clevis before attaching the cle-

vis to the control horn. After the clevis is attached to the control

horn, slide the clevis keeper of the ends of the clevis to insure it

will not prematurely open.

Step 8. Repeat the process for either the rudder or elevator,

whichever one you have not done.

Installing the Throttle Pushrod

Sequence of installing the throttle pushrod in this manual is

for most two and four-stroke engines. Installation may slightly

vary, depending on the type/brand of engine you use to power

your Ultra Stick

™

40.

Step 9. Locate the smaller 1.5 mm, 16" pushrod and make a

"Z" bend in one end using needle nose pliers or "Z" bend pliers.

Step 10. From the firewall, insert the wire though the

previously installed throttle pushrod wire guide tube.

CONTINUED