Instruction manual

Section 15: Installing the Rudder, Elevator, and Throttle Pushrods

Step 11. Install the easy connector to the throttle servo arm by

inserting the bottom post through the second hole from the end

in the servo arm. Install the snap washer on the easy connector

stem securing it to the servo arm.

Step 12. With the throttle pushrod wire installed into the fuse-

lage slide the wire into the hole in the easy connector but do not

tighten. Connect the "Z" bend of the pushrod to the throttle arm.

It might be easier to remove the carburetor from the engine and

install the throttle arm to the "Z" bend.

Step 13. Turn on your radio system and center your trans-

mitter’s throttle stick and trim and center your throttle servo arm.

Put the throttle arm of your engine to be half open/closed.

Step 14. With your radio system on and throttle controls cen-

tered and throttle arm in the half open/closed, secure the throttle

pushrod wire to the easy connector by tightening the screw in

the top of the connector to the pushrod wire.

CONTINUED