Instruction manual

56
CONTINUED
Section 19: Programming Guide —
JR XP783/XP347/XP388S
Select Aircraft Type
+
CLR
–
UP CHDN
Select Aircraft Type
HELI
ACRO
GLID
TYPE
GLID
Function Being
Programmed
: Helicopter
: Airplane
: Glider
Step 2. Selecting model type (GLID): In System Setup
mode, press the Up key until the “TYPE” screen appears.
Now press the (+) key until “GLID” appears on the screen.
Setting Condition
INH : Inhibit
ACT : Active (Mixing ON)
V–TL
INH
Wing Type Display
V-TL : V-Tail
DUA-F : Dual Flap
MIX
Reverse Current Setting
(INH - ACT)
Current Setting OFF (INH)
+
CLR
–
Wing Mixing
Display Change
UP
CHDN
Step 3. Activating dual flap: In System Setup mode, press
the Up key until the “V-TL INH” screen is displayed. Press the
CH key to access the mix “DUA.F” screen. Press the (+) key to
activate (ACT) the dual flap function.
Flap Channel Input Selection
(pot. 6 - SW+T)
Reset to POT. 6
+
CLR
–
UP CHDN
FLAP
POT.6
Current Flap Channel Input
POT .6 : Flap Knob
SW+T : Flap Switch and Pot. 6
Function Being Programmed
Step 4. Assigning the flaps to the flap switch: In System
Setup mode, press the Up key until “FLAP POT.6” appears on
the screen. Press the (+) key so that “SW+T” appears.
Note: With the JR X347 the flaps are automatically assigned
to the switch, this step should be ignored.