Instruction manual

61
CONTINUED
Section 19: Programming Guide —
JR XP783/XP347/XP388S
Step 13: Setting up Crow: Crow will be assigned to the flap
switch and will be activated when the switch is in the down posi-
tion. We’ve already set the flaps to the proper down position in
Step 7 travel adjust. Now we need to add the ailerons up
3
/4"
and the elevator down
5
/8".
FL-A
0
%
MIX
Function Being
Programmed
Current Mixing Value
Increase/Decrease Mixing Value Reset Mixing Value to
Factory Default 0%
+
CLR
–
To Mixing Activation
To Butterfly/Crow
Mixing
To Flap to Elevator
Mixing
UP
CH
DN
To Offset Value
Increases/Decreases
Corresponding Mixing Value
Clears Current Mixing Value —
Transmitter Returns to the
Default Value of 0%
Note: Only the flap input indicated by
the position indicator will be cleared.
For example, if “U” were displayed and
CLR were pushed, the “D” value would
still be retained by the transmitter.
+
CLR
–
To Mixing Activation
Selection (Press Once)
To Flap Offset Setting
(Press Twice)
To Flap to Aileron
Mixing
To Differential
UP
CH
DN
F-E.D
0
%
MIX
Function Being
Programmed
Flaps to Elevator Mixing Value
(Range ±125%)
POS
Position Indicator
Flap Operating Direction
D : Down Flaps
U : Up Flaps
Step 14. Flap to ailerons mixing: Press the Up key until
the “MIX FL-A” screen appears. Now press the CH key to access
the “MIX FA: SW” screen (flap-to-aileron switch selection).
Press the (+) key until “F-DN” (flap-down) appears on the
screen. Now press the CH key twice to return to the “FL-A”
screen. Move the flap switch to the down position. Next press
the (+) key until both the ailerons go up 3/4 ". If the ailerons go
down, press the (-) key.
Note: With the XP347, the flap-to-aileron mix is always on
when programmed.
Step 15. Flap-to-elevator mixing: In Function mode, press
the Up key until “MIX F-E” appears on the screen. Next press the
CH key to access the “FE: SW” (flap-to-elevator switch selec-
tion) screen. Press the (+) key until “F-DN” (flap down) appears
on the screen. Now press the CH key twice to return to the “MIX
F-E” screen. With the flap switch in the down position, press the
(+) key until the elevator comes down
1
/4". If the elevator goes
up, use the (-) key to reverse this.