Instruction manual

Section 19: Programming Guide — JJR XP8103

CONTINUED

Note: When setting up a new aircraft, it’s important to reset the programming to the factory defaults.

SELECT

CH CH CLEARUP

Press to return to

factory preset data.

Model number

to be reset

Step 1. Resetting the programming to factory defaults:

Hold down both the Up and the Down keys and turn on the radio

to enter System Setup mode. Now press the Up key three times

to move the cursor to the “MDL Reset” menu (Model Reset).

Press the Up and Down keys simultaneously to enter the “MDL

Reset” screen. Now press the CLR key to reset the programming

to the factory defaults.

SELECT

CH CH CLEARUP

Press to move arrow

and select model type.

Model Number

Helicopter

Airplane

Glider

Arrow Indicates

Existing Model Type

Step 2. Selecting model type (GLID): In System Setup

mode, press the Up key until the “Type SEL” screen appears.

Now press the (+) key until the cursor points to “GLID” on

the screen.

Setting condition

Function now being

programmed

Press + or (-) key to inhibit

or activate function.

SELECT

CH CH CLEARUP

Press either CH key to select

v-tail or dual flap.

Step 3. Activating dual flap: In System Setup mode, press

the Up key until the “Wing Type” screen is displayed. Press the

CH key to move the cursor to “DUAL FLAPS.” Next press the

(+) key to activate (ACT) the dual flap function.