Instruction manual

65
Press to reset Flap
input to Pot 6.
Current Flap Channel Input
Pot 6: Flap Knob
FLP.SW+PG: Flap Switch and Pot 6
Press either the (+) or (-)
key to select Pot 6 or
FLP.SW +P6.
DN
SELECT
CH CH CLEARUP
Step 4. Assigning the flaps to the flap switch: In System
Setup Mode press the Up key until “Input Sel.” (Flap Input)
appears on the screen. Press the (+) key so that “FLP.SW+P6”
appears in the lower screen.
Channel Being Programmed
SPOI Throttle
AIL1 Aileron Right
ELEV Elevator
RUDD Rudder
AIL2 Aileron Left
FLAP Flap (Right)
AUX2 Flap (Left)
AUX3 Extra Channel (Aux3)
Use + or -
to change
(normal/reverse)
Channel Selection
(1-8)
Reset travel direction to
factory preset (normal)
DN
SELECT
CH CH CLEARUP
Step 5. Setting servo reversing: Turn the transmitter off
and then back on again. Press the Up and Down keys simultane-
ously to access the Function mode. Press the Up key until the
“REV.SW” function appears on the screen. Press the Channel
key to select each channel and check that the servo direction is
operating correctly for each channel. To change the direction of
the selected channel, press the (+) or (-) key. Check and adjust
all channels as necessary.
Note: When the three-position flap switch is pulled down,
the flap should come down. If they go up, reverse the
direction of channel 6 (FLAP) and or 7 (AUX 2).
Note: Because the GLID model programming is being used,
the transmitter refers to the throttle function as SPOI
or spoilers. Any time “SPO”I is displayed, it functions
as throttle.
Section 19: Programming Guide — JJR XP8103
CONTINUED