Instruction manual

69
Section 19: Programming Guide — JJR XP8103
CONTINUED
At rate, press to
increase/decrease
mixing value (± 125%)
At switch, press to
change switch selection.
Function Selection
→Rates→Switch→Offset
Press to return the mixing
value to zero or to return the
active mixing switch ON.
DN
SELECT
CH CH CLEARUP
“SW OFF” appears when the flap mixing is in the
middle or upper position.
Flap to Aileron Mixing Value (± 125%).
Indicates current mixing switch activated
Flap Offset Value
Indicates the function
being selected:
Step 13. Flap-to-aileron mixing: Press the Up key until the
mix “FLAP-AILE” screen appears. Now press the CH key to
move the cursor to the SW: position (flap-to-aileron switch
selection). Press the (+) key until “FLP-D” (flap down) appears
in the screen. Now press the CH key twice to return the cursor to
the RATE position. Move the flap switch to the down position.
Next press the (+) key until both the ailerons go up
3
/4". If the
ailerons go down, press the (-) key.
Note: The flap switch must be in the down position to
change the rate value.
Step 12. Setting up Crow: Crow will be assigned to the flap
switch and will be activated when the switch is in the down posi-
tion. We’ve already set the flaps to the proper down position in
Step 8 travel adjust. Now we need to add the ailerons up
3
/4"
and the elevator down
5
/8".
Flap Operating Direction
(D=Down, U=Up)
“SW Off” appears when the flap mixing is in the
middle or lower position
Flap to Elevator Mixing Value (± 125%)
Indicates current mixing switch activated
Flap Offset Value
At rate, press to
increase/decrease
mixing value (± 125%)
At switch, press to
change switch selection.
Press to return the
mixing value to zero or
to return the active
mixing switch to ON.
DN
SELECT
CH CH CLEARUP
Indicates the function
being selected:
Step 14. Flap-to-elevator mixing: In Function mode, press
the Up key until the mix “FLAP-ELEV” appears on the screen.
Next press the CH key to move the cursor to the SW (flap-to-
elevator switch selection) position. Press the (+) key until the
“FLP-D” (flap down) appears on the screen. Now press the CH
key to return the cursor to the “Rate” position. With the flap switch
in the down position, press the (+) key until the elevator comes
down
1
/4". If the elevator goes up, use the (-) key to reverse this.
↓
Rate
↓
SW
↓
Rate
↓
SW
Function Selection
→Rates→Switch→Offset