Instruction manual

74
Step 10. Programmable mix for elevator-to-flap, Code 52:
Enter Code 52, Programmable Mix 2, and press the “3” key and
then the “6” key to select the ELEVATOR as master and the
FLAPS as slave channels. Press Enter, then press the Page key
to select the switch screen. Below MX press the SEL key to
select the mix switch to operate the mix. This will allow the ele-
vator-to-flap mix to be turned on/off using the mix switch. Press
the Page key twice to return to the mix screen. With the mix
switch (back right side of transmitter) in the forward position,
hold up elevator and press the (+) key until the flaps go down. If
the flaps go in the wrong direction, press the Turn key. Mixing
percentage value of 35% is a good place to start. Now with
down elevator, press the (+) key until the flaps go up. Also use
35% as a starting point here. Later you can adjust these values
to suit your flying style.
Step 11. Programmable mixing of aileron-to-flaps, Code 53:
Enter “Code 53, Programmable Mix 3.” Press the “2” key and
then the “7” key to mix aileron to AUX 2, then press Enter.
Press the Page key to access the switch select screen and press
the SEL key below MX. This will turn on/off the aileron-to-flap
mix with the mix switch (located at the back left of the transmit-
ter). Press the Page key twice to return to the “Programmable
Mix 3” screen. With the mix switch in the forward position,
press the (+) key while holding the right aileron control stick
until the value reads 100%. If the flap moves opposite the
aileron, then press the Turn key. Now holding left aileron with
the control stick, press the (+) key until 100% is achieved. Press
the Turn key if necessary.
CONTINUED
Section 19: Programming Guide —
JR 10X/10SxII/10Sx
Switch or stick position where mixing
values will become active. All except
FIX will have a 0 and a position 1
Indicates
direction of mix
Indicates program
being accessed
Touch the
keys to alter mixing
value
Elevator is the
master channel,
Flap is the slave
Touch to
change mix direction
Refer to mixing
value and directions
Shaded box indicates
value being adjusted
Mixing
percentage
value
Switch or stick position where mixing
values will become active. All except
FIX will have a 0 and a position 1
Indicates
direction of mix
Indicates program
being accessed
Touch the
keys to alter mixing
value
Aileron is the
master channel,
Flap is the slave
Touch to
store offset or
basic mixing point
Refer to offset
operation
Touch to
change mix direction
Refer to mixing
value and directions
Touch to
proceed to other
mixing screen
Touch to
memorize and exit
program
Shaded box indicates
value being adjusted
Mixing
percentage
value
Offset value
* Flap Switch
UP = Normal
MID = Takeoff flaps
DOWN = Crow
* Mix Switch = Turns on/off aileron-to-flap
and elevator-to-flap mixes