Instruction manual

78
Section 19: Programming Guide — Futaba 8UA/S
CONTINUED
Channel Display
Left/Up
Servo Throw
Range: 30–140%
Right/Down
Servo Throw
Initial value = 100%
Data Input
These keys are used to select the channel to be set in ATV.
You can reset to the initial values by pressing the (+)
and (-) keys simultaneously.
Channel display
No. Channel Name No. Channel Name
CH1 AI = Right Aileron CH5 Right Flap
CH2 EL = Elevator CH6 FL = Left Flap
CH3 TH = Throttle CH7 Channel 7 Left Aileron
CH4 RU = Rudder
* The blinking item is what is being set.
Step 6. Adjusting the travel volume: Press the two Basic
Menu keys simultaneously to enter the Basic mode. Now press
the Mode key until the “ATV” (adjustable travel volume) screen
appears. Pressing the Cursor key will advance through the chan-
nels, while pressing the (+) or (-) key will increase or decrease
the travel of that channel. It’s necessary to adjust each direction
of each channel by moving that selected channels stick in the
desired direction. Adjust each channel to the following.
Throttle — Full open to full closes with trim
Aileron — 1
1
/
4" up, 1
1
/
4" down
Elevator — 1
7
/
16" up, 1
7
/
16" down
Rudder — 3" right, 3" left
The value of the stick adjusted
by stick operation blinks.
Step 7. Setting dual rates: In Basic mode press the Mode
key until the “D/RE” screen appears. This is the dual rate pro-
gram. Press the Cursor to access the aileron, elevator or rudder
channels, then press the (+) or (-) key to change the values.
Note that two dual values are available by toggling that channel’s
dual rate switch. On all three channels, high rate should be
adjusted to 100%, while low rate should be set at 50%.
Channel display: AI = Aileron,
EL = Elevator, RU = Rudder
Indicates top or bottom switch
position (top shown)