Installation Instructions

Railing Installation:
Your installation guide for Fusion®
Post Cap (2)
Post Sleeve (2)
3-1/2" Premium Deck
Screws
Top Rail (1)
Handrail Insert (1)
Post Spindle (2)
Spindles
3" Composite
Deck Screws (6)
Traditional 6’ section: ~ 15
Check with local building code
Support Block(1)
Check with local building code
Lower Railing (1)
Ring Base (2)
Fusion® Railing System:
!
Make sure the post sleeve and ring base have been installed. Make sure the post is plumb
and level. Properly size the upper and lower rail and the top cap by measuring the distance
between the two post sleeves, and cut to desired length. Make sure the spindles are all the
same length, measure and cut accordingly.
18
6" Handrail Insert (1)
i
Note: It is very important to verify spindles are all the same length. Measure and cut
accordingly.
To apply this method as a stair rail assembly, please see preparation instructions, page 9.
Fusion railing is installed with a composite insert; stair railing assembly will use lower rail
for both top and bottom rail.
Rail Section:
Upper
handrail
Handrail
insert
Lower handrail
Spindle
Support
block
Post Sleeve
Top Cap