Installation Instructions

ManualsBrandsUltraDeck ManualsBuilding materialsQuickCap Composite Deck Resurfacing 6" Sample

CLADDING DIMENSIONS:

UltraDeck

Triumph

™

Fusion

, Inspire

™

: ⁄" x 12⁄" x 12'

UltraDeck

Rustic

™

: ⁄" x 10⁄" x 12'

Cladding will provide a professional ﬁnished look to your deck. UltraDeck

cladding can be used as

skirting to cover joist members, elevated support posts, outside edges of board proﬁles, stair

stringers, and other exposed lumber products.

When attaching cladding to the deck frame, use color-matched cladding screws. In order to be

sure there is enough room for proper expansion and contraction of the UltraDeck

planks, leave

a ⁄" gap between cladding and deck boards. Pre-Drill with a ⁄" bit, through the cladding only,

then starting 1⁄" from the top and bottom edge of the cladding every 12". Screws should be snug

but it is important not to over tighten the screws.

For long distances requiring multiple pieces of UltraDeck

cladding, use opposing miter cuts at the

seam to reduce visible joints, leaving a ⁄" gap between the cuts to allow for expansion, Figure 1.

UltraDeck

Cladding UltraDeck

Cladding

Outside Joist

Joist

Deck Board

45° Miter Cut on Cladding

Endcaps are a great way to protect your UltraDeck

with hollow proﬁles by helping

create a barrier against moisture, dirt, and insect infestation. They can provide a clean, professional

look to end cuts made at a 90° angle. Endcaps are not necessary for any butt joints in the deck. If

desired, a silicone adhesive caulk may be used to further secure endcaps to the planks.

ULTRADECK

CLADDING:

ULTRADECK

PLANK ENDCAPS:

*For Natural

™

boards only

Fig. 1

⁄" Gap

⁄" Gap

UltraDeck

CLADDING & END CAP INSTALLATION