Manual
CH0007 Operation Manual
Newark, New York
|
315-332-7100
|
Fax: 315-331-7800
©2010 Ultralife Corporation • www.ultralifecorp.com • All specific subject to change without notice
The information contained herein is for reference only and does not constitute a warrant of performance • 30 SEP 10 UBI-5166 Rev: A
Page 8 of 25
2.1 Physical Description
2.1.1 Exterior – Front View
Figure 1: CH0007 Front View
(A) Charger Body – The charger body is made from aluminum
(B) Charger Lid – The charger lid is made from aluminum
(C) Charger Lid View Ports – Several areas of the charger lid have polycarbonate label- covered
windows for viewing the status of the charger without opening the lid.
(D) Lid Latches – Metal push button-style latches secure the lid tightly to the base.
(E) USB Input Connector – There is a round circular connector that houses a USB input socket. This
connector should be protected by a screw-on cap when not in use. (cap is provided and attached
using chain)
(F) Power Connector – There is a circular connector that houses the power socket. This connector
should be protected by a screw-on cap when not in use (cap is provided and attached using chain)
(G) Pressure Release Vent – Watertight pressure release vent helps balance internal pressure of
charger case.
(H) ID Label – Shows manufacturer information and serial number