Ultraloq UL3 Fingerprint and Touchscreen Smart Lock Installation Instructions Welcome ( V1.
Installation Video Please watch our easy step by step installation video before attempting to install your Ultraloq UL3 Fingerprint and Touchscreen Smart Lock. www.u-tec.com/support If you have questions regarding the installation process Please contact us at customerservice@u-tec.com Important Notes • Only use a power drill for making a hole. Do not use it for installation. • Install and test the lock with the door open to avoid being locked out.
Included in the box Exterior Assembly Interior Mounting Plate Strike Latch Screw A Screw B Backup Keys Screw C Spindle Drill AA Batteries AA alkaline Handle Interior Assembly -2- Spring Screw D Screw E Screwdriver
! Preparing Door Check the door’s dimensions 13/8”~ 13/4” (35 mm-44mm) Door Edge 2 3/4” (70 mm) OR 2 3/8”(60 mm) 2 1/8”(53 mm) Hole 1” (25 mm) Drill a hole in the door Use the Drill Template provided in the box.
! Preparing Door If your door thickness is over 16.5”(42mm), Please install this spring.
2 Installing Latch and Strike 1. Install latch on the door. Make sure the latch angle faces door jamb. 2. Install the strike on the door frame, ensuring you allow for the bolt to be centered in the strike. Angle faces jamb m 0m ~7 60 Adjust the latch basket length Screw A Screw A Before installing the lock on the door 1. Loosen the screw holding the battery cover. 2. Slide the battery cover up and out (note the two tabs at the bottom of the battery cover). 3.
Installing Exterior Assembly 3 1. Install the exterior assembly. Route the cable under bolt and through hole stated below.
4 Installing Interior Mounting Plate 1. Install interior mounting plate. Secure it to the exterior assembly using screws. 2. Plug in the spindle.
Installing Interior Assembly 5 1. Attach the cable to the interior assembly printed circuit board (PCB) by lining up notches on the cable connector to slots on the PCB connector. Press the connector in firmly using thumbs until completely seated. 2. Secure interior assembly using screws.
6 Installing Batteries 1. Insert 3 AA alkaline batteries. 2. Install battery cover and tighten the screw.
Installing Handles 7 1. Press lever handles onto handle posts. 2. Test the mechanical operation of the lock by rotating handle from inside. The movement of the bolt should be smooth and unobstructed. If the operation is not smooth, review the previous steps to ensure proper installation. If the handles are installed in the wrong direction, you need to remove them and re-install. To remove the handle, you need to insert the screwdriver into the hole in the handle, push in and hold.
! Handle plug position The handle is plugged in correctly. or The handle is not fully plugged in.
Note Date / /
Note Date / /
Note Date / /
U-tec and Ultraloq brands and products are trademarked and protected under law in the United States. Unauthorized use is prohibited. Ultraloq is sub-brand of U-tec Group Inc. 2016 © U-tec Group Inc. All Rights Reserved.
