2/7/2020 Model # 358-SD Page 1 of 11
SAFETY WARNINGS & EQUIPMENT INSPECTION • Owners and installers please note these safety warnings and make use of this checklist on a regular basis. • Follow installation instructions when erecting equipment. • Ground surfaces around equipment should be restored as needed. Concrete footings should never be exposed. Surface depth should comply with ASTM and CPSC specifications. • Check for and repair damage caused by wear or vandalism, a major factor in injury causing situations.
2/7/2020 HARDWARE 5/16" X 1" Machine Bolt 5/16" Washer 5/16" Kep Nut 800-45-ULTRA www.ultra-site.
2/7/2020 TOOLS REQUIRED 1/2" Wrench 1/2" Socket Wrench Tape Measure 800-45-ULTRA Level www.ultra-site.
ULTRA SITE PRODUCT SPECIFICATIONS 358-SD 46” PORTABLE TABLE WITH 4 SEATS Top & Seats: 11 gauge die formed angle frame 1”x1-7/8” with 3” radius corners. 7 gauge x 1-1/2” flat bar center support and mounting bracket understructure. Top is additionally supported to the corners with 7 gauge x 1-1/2” flat bar. Electrically MIG welded. Coating: Oven fused functionalized polyethylene copolymer-based thermoplastic.
COMPONENTS 1 4 8 9 7 5 ITEM NO. PartNo DESCRIPTION Qty.
2/7/2020 STEP 1 5 7 6 Attach the Extension Tabs to the 46" Square Top using specified hardware. 1 800-45-ULTRA www.ultra-site.
2/7/2020 STEP 2 2 3 Attach the 358 Legs to the Extension Tabs using specified hardware. 800-45-ULTRA www.ultra-site.
2/7/2020 STEP 3 9 Attach the Crossbrace between the table legs as shown using specified hardware. 800-45-ULTRA www.ultra-site.
2/7/2020 STEP 4 8 7 5 6 Attach the 3' Seats to the 358 Legs using specified hardware. 800-45-ULTRA www.ultra-site.
2/7/2020 OVERALL DIMENSIONS 36" 79 1/4" 46" 12" 30 3/8" 18 1/4" 800-45-ULTRA www.ultra-site.