Specifications

Changing the Outgoing Auto-Answer Memo
+/
AUTO-ANSWER
You can change your outgoing Auto-Answer Memo by typing a new Memo name
and contents when you turn on Auto-Answer. Follow these steps to change your
Auto-Answer Memo:
1. Press the Auto-Answer key ( + /
AUTO-ANSWER ). You will see
ANSWER MEMO and the name of your answer Memo on the display.
2. Type a new name and press .
3. Type the new message and press . Auto-Answer is on.
4. If you do not want Auto-Answer on right away, press or turn off the
Minicom 6000 Plus. Auto-Answer will use the new Memo the next time you
turn it on.
NOTE: Your outgoing Auto-Answer Memo is the same as any other Memo. It is
saved in Memo memory and you will see its name when you read through the list
of Memos. See Chapter 8 for more information about Memos.
Auto-Answer Options
Setting the Number of Telephone Rings
+/
OPTIONS
You can set Auto-Answer so that it waits between 2 and 9 rings before answering,
or you can use the TS (Toll Saver) setting.
The TS setting is used with remote message retrieval. It tells the Minicom 6000
Plus to answer after 2 rings if you have messages or 5 rings if you do not. This
saves the cost of a call if you have no messages, because you can hang up after 3
rings.
Follow these steps to change the number of rings:
1. Press the Options key ( + /
OPTIONS ).
2. Press until the display says
AUTO-ANSW RINGS (2). The original
setting is
(2).
3. Press the to choose a number between
(2) and (9) or (TS).
4. Press to exit the Options menu.
Esc
Spacebar
Return
9Ctrl
9Ctrl
Esc
Esc
Return
+
=
Ctrl
+
=
Ctrl
42 • AUTO-ANSWER