Specifications

The printer prints only the bottom half of characters
The print head should be replaced. Contact your dealer or Teletec.
On battery power, the printer prints too slowly or lightly
The batteries are low. Connect the AC adapter for 24 hours to recharge the
batteries.
Power
The Ring Indicator does not work
Be sure the plastic tab has been pulled out of the battery compartment and that
you have plugged in the Minicom 6000 Plus for at least 24 hours.
The batteries run down too soon
The batteries may be old, and need to be replaced. See About the Batteries on
page 72.
The Minicom 6000 Plus does not turn on when you press the On/Off
switch, or the power light blinks even when the AC adapter is
plugged in.
Be sure the electrical socket is working. Be sure you are using the correct AC
adapter—it should be a 9VDC, 1.2A adapter. If you still have a problem, contact
your dealer or Teletec.
The Minicom 6000 Plus works fine in the evening, but does not
work during the day
You may have plugged the AC adapter into a time-switch controlled socket. Try a
different socket that you are sure is not controlled by a time-switch.
Clearing all Memory
You can clear all conversations, Memos, Directory entries, and Auto-Answer
messages at one time. Follow these steps to clear all memory:
1. Press the Clear key ( + /
CLEAR ). CLEAR (CONVERSATION) is
displayed.
2. Press the to change the setting to
(ALL MEMORY).
3. Press .
4. Press to clear all memory. (Press if you decide not to clear it.)
NY
Return
Spacebar
8Ctrl
SERVICE • 75