Owner's Manual

EN
10
OPERATION
10A. Unloading a Pellet
Fire the pellet at a SAFE TARGET to unload the airgun. If this is not practical, put
the air rie “ON SAFE”, cock the airgun to open the barrel, and push the pellet
from the chamber by running a cleaning rod through the muzzle end. Insert 2
RWS Cleaning Pellets and discharge into a safe target.
10B. Removing a Jammed Pellet
If a pellet is jammed in the barrel, DO NOT reload
the air rie.
1. Cock the air rie (see STEP 4. COCKING
YOUR AIR RIFLE), point the air rie in a SAFE
DIRECTION, put the air rie in the “OFF SAFE”
position and squeeze the trigger to re.
2. Break the barrel open slightly (without pulling
the barrel all the way down to the point that it
cocks) and look down the breech to see if the air rie is jammed (see illustration
8). NEVER LOOK DOWN THE MUZZLE.
3. If the air rie is still jammed, with the barrel opened slightly, insert the correct
caliber ramrod into the muzzle and push the jammed pellet out. Do not try to
reuse that pellet. If you are not able to unjam your air rie, contact Umarex USA’s
Service Department.
10. Trouble Shooting
Breech
Muzzle
Ramrod
Illustration 8
9. Adjusting the Sights
The Umarex
®
Syrix Air Rie is equipped with an
adjustable rear sight, with vertical and horizontal
adjustments.
Elevation Settings—If the rie shoots high: turn the
top wheel(1) clockwise (see illustration 7). If the rie
shoots low: turn the wheel counterclockwise.
Windage Settings—Windage settings are controlled by turning the knob(2)
on the side (see illustration 7). If the air rie shoots to the right: adjust
counterclockwise. If it shoots to the left: adjust clockwise.
Illustration 7