Instructions Manual

DO NOT TANGLE THE POWER CORD
REGULAR MAINTENANCE OF THE TREADMILL
 STORAGE: Keep your equipment in a enclosed place, away from dust or
humidity. Don’t store it neither in a garage or in a indoor backyard, or near the
water. Humidity, dust and water could damage it and have an effect on its
functioning
 ELECTRIC CABLE: Make sure that the cable and plug are in perfect conditions.
Electric cables must be away from hot surfaces
 SCREWS AND CONNECTING CABLES: Supervise and tighten the screws on a
regular basis, because due to the vibration the screws and nuts tend to loosen.
LUBRICATION: Turn over the running belt at the back of the mainframe. Insert
the lubricant pot as deep as possible into the middle of the running belt. Apply
the lubricant onto the inner side of the running belt.
Lubricate both sides of the running belt.
After the lubrication is completed, start the machine at
1km/h to let the running belt bring silicon all over the
board.
< 3 hours/week
2 months
4 – 7 hours/week
1 month
> 8 hours/week
15 days
 ALIGN AND TIGHTEN THE BELT OF THE TREADMILL
 ALIGN THE BELT: Due to its use, the belt can move off
center. If the belt has moved to the left, start treadmill
and increase the speed to 3KM/H .Use the 5mm Wrench to
turn the fixed left bolt clockwise or turn the fixed right
bolt counterclockwise. Don’t tighten the belt too much in
order to be able to walk. Repeat this procedure until the
belt is properly aligned.
如果跑带左偏,则顺时针调节左
边螺丝或逆时针调节右边螺丝
如果跑带右偏,则顺时针调节右
边螺丝或逆时针调节左边螺丝
If deviate to the right, then
adjust the screw on the right side
clockwise or the screw on the left
side anticlockwise.
If deviate to the left, then
adjust the screw on the left side
clockwise or the screw on the right
side anticlockwise.