Operating instructions

Unpacking and setting up the balance

Positioning plate of the weighing cell in the desired location and secure (with screws or

by gluing). The foot of the weighing cell should be in the hole (A).

Weighing cell in the positioning plate. Make sure that the front foot of the weighing cell

is in the circular hole. The weighing cell must sit ﬁrmly between the two white plastic

bushings (B). For precise positioning, unfasten the ﬁxing screws of the plastic bushings,

move both bushings towards the weighing cell and tighten the screws again.

Remove the shipping lock: Tilt the locking rocker (C) of the weighing chamber cover to

the right and remove the weighing chamber cover by pulling it forwards. Carefully remove

the shipping lock (foam pad with adhesive tape), then replace the weighing chamber

cover and lock.

Note: The shipping lock protects the weighing cell and ensures that the weighing pan

and the weighing sample holder remain ﬁxed in the desired position. Therefore retain the

shipping lock for future transport of the weighing cell.

Level the weighing cell: Turn the two leveling screws (D) at the back of the housing until

the air bubble is in the center of the level indicator (E).

2.4 Assembly of the balance and connection to the power supply

Use the supplied connection cable to connect together the control unit and the weighing cell.