CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 1 1.4 Hyundai Sonata In-Dash Navigation DIY Installation Guide [Single CD Player Use Only] MODEL: Hyundai Sonata 2012+ (Professional Use) WWW.BUYUNAVI.COM Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 BU No. 2 Hyundai Sonata In-Dash Navigation DIY Installation Guide VERSION. 1.4 PAGE. 2 DISCLAIMER: This ‘Do-It-Yourself Installation Guide’ is intended for informational and reference purposes only. We do not recommend implicitly or explicitly, to anyone, performing any of the procedures described in this guide.
CLASSFICATION. MODEL. Installation Manual DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 3 (Continued) Control box + SD Card Front bracket replacement Side mounting brackets (L & R) Trip interface board + Screws External speaker GPS antenna + Magnetic plate Pass. Airbag/Seat Belt lamp cable (Telltale Lamp) SD + USB interface cables Information & Manual SMART cable Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. MODEL. Installation Manual DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 6 1.4 > INSTALLATION STARTS HERE < Carefully remove the side crash pad garnish (L/R). (Apply protective tapes and take care not to damage and scratch the interior dash and its related parts) Loosen the two mounting screws securing the center fascia panel. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 7 1.4 Gently pull out the center fascia panel and disconnect all connectors/hoses behind it. (Installation is the reverse of removal) After the center fascia panel has been removed, disassemble the following components from the back and directly transfer it to the new fascia kit: Air vent assy.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 8 Removed factory components transferred to the UNAVI fascia kit. Remove the mounting screws (4EA) then pull out the audio head unit. (Installation is the reverse of the removal) Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 9 Rear view of the audio head unit after removing connectors and cables. Remove the rear frame stabilizer. Image of center fascia panel and audio head unit removed. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 10 1.4 Remove the screws (6EA) securing the BlueLink modem as shown. After the modem is disassembled from the dash panel, use a Torx driver (T15 bit) to remove the silver mounting bracket screws (4EA) off of the BlueLink modem. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 11 1.4 Cut off the back plastic frame behind the dash along the dotted lines. After cutting off the plastic frame, the metal piece sticking out from the back must be bent or removed to provide room for the relocated audio head unit to sit in properly. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 12 Sample image of the back of the dash panel. Image of the BlueLink modem removed. Proceed with caution when disassembling the modem. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 13 1.4 Wrap the modem with a protective material such as a bubble wrap or shield wrap. Relocate the modem behind the panel by sliding it underneath the chassis frame as shown. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 14 1.4 Remove all screws securing the audio faceplate as shown. Use a flathead screwdriver to release the tabs and gently pull out the faceplate. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 15 Image of the factory faceplate removed from the audio unit. *Take care not to damage the ribbon connector* Release the lock and gently slide out the ribbon cable. Disconnect the ribbon cable from the back of the audio faceplate ONLY. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. MODEL. Installation Manual DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 16 1.4 Remove the screws securing the front bracket. (These screws will be reused) Remove the front bracket. Remove the mounting brackets on each side. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 17 1.4 Screw on the replacement mounting brackets (Left and Right) as shown. Assemble the Trip Interface board onto the front replacement bracket as shown. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 18 Slide out the ribbon connector through the bottom opening of the front replacement bracket. [WARNING] This TRIP MODULE is designed for specific models. Improper use such as failure to follow instructions and use with incompatible radio will damage this module and the radio unit! The ribbon cable is inserted into the Trip Interface board.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 19 NEVER attempt to connect the ribbon cable to the Trip Interface Board like the picture shown above as it may cause permanent damage to the audio unit! Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 20 Please proceed with CAUTION when inserting the ribbon cable into the Trip Interface board. DO NOT twist the cable as this may result in a damaged board and/or the audio unit! The Trip Interface board is designed to communicate with either side of the pins.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 21 Use remaining screws from the original bracket to mount the front replacement bracket. (Image shown above may vary) Route the SD/USB interface cables around from behind the glove box and out through the center dash panel opening. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 PAGE. VERSION. 22 1.4 EXAMPLE: Mount the control box inside the glove compartment as shown. Use Unibit to drill a hole on the back of the glove box (about 3/4-inch) just wide enough for the SD/USB interface cables to slide through.**Proceed with Caution** Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 23 1.4 Mount the control box inside the glove box using a double-sided tape or Velcro. Another recommended location to mount the control box is inside the center pocket as shown above (requires to drill hole). Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 24 Connect the GPS antenna to the female connector labeled “GPS”. EXAMPLE ONLY Make sure the GPS receiver is mounted (rounded side up facing the sky) to a non-metallic panel or on the front windshield glass. Route the antenna cable carefully to avoid damage. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 25 Factory clock display cable plugs into the Pass. Air Bag/Seat Belt lamp cable as shown. The male connector of the Passenger Airbag/Seat Belt lamp cable plugs into the back of the factory clock display console as shown. (It is optional to retain this display console in the vehicle) Information & Manual Copyright © 2013 UNAVI USA, Inc.
CLASSFICATION. MODEL. DOCUMENT NO. ENB-X2 Installation Manual Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. 1.4 PAGE. 26 Connect the external speaker to the female connector labeled “BUILT-IN SPEAKER” This speaker will allow sound output from the UNAVI system when the audio is in XM/Radio/CD/MP3/Bluetooth mode. Sound output from the system will use the factory speakers under “AUX” mode only.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 PAGE. VERSION. 27 1.4 Connect the main factory audio cable (24-pin) to the SMART cable harness. Clear of any obstructing cables or components behind the dash panel. Reconnect the remaining audio unit connectors and cable as shown. Check the cables are not being too tightly squeezed in the back of the audio unit. Information & Manual Copyright © 2013 UNAVI USA, Inc.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 28 1.4 Mount the audio unit back into the dash panel using the original screws. Plug in the 6-pin “TRIP POWER” connector to the Trip Interface board as shown. Plug in the 5-pin “TRIP PCB” connector to the Trip Interface board as shown. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 29 1.4 Connect the 10-pin control keypad cable to the Trip Interface board as shown. Plug in the 3-pin “TELLTALE LAMP” cable to the Passenger Airbag / Seat Belt indicator lamp located behind the UNAVI fascia kit as shown. Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.
CLASSFICATION. Installation Manual MODEL. DOCUMENT NO. ENB-X2 Hyundai Sonata In-Dash Navigation DIY Installation Guide BU No. 2 VERSION. PAGE. 30 1.4 Plug in the remaining cables to the back of the LCD panel as shown. [INSTALLATION COMPLETE] For additional support and information, please visit us at www.buyunavi.com Thank you for choosing UNAVI! Information & Manual Copyright © 2013 UNAVI USA, Inc. All rights reserved.