Instructions / Assembly

Step 6:
Set the hinge pin when the hinges are
aligned and tighten the hinge pin
security screw with the T-10 bit. Place
the hinge caps at the top and bottom of
each hinge.
Step 7:
Install door handles with provided
screws.
Step 8:
The roller catch may need adjustment
for the door to open and close properly.
Using a 2.5 mm Allen key, adjust the
roller in or out at the hole just below the
roller.
Step 9:
The hinges allow for horizontal and
vertical adjustments to the door. To
make adjustments, loosen the two large
screws using a T-25 drill bit. This allows
the hinges to freely and safely move in
the next step.
Step 10:
Use a T-125 drill bit to make
adjustments. To make horizontal
adjustments, turn the center screw. To
make vertical adjustments, turn the
screw next to the center screw. Once
adjustments are complete, make sure to
tighten the screws that were loosened in
Step 7.