Instructions / Assembly

1 ASSEMBLY
5
Figure 2
Figure 3
Hardware bag a
2. Attach the Small (triangular) Face Plate (item #8) with
seven (7) more M6 x 20 flat head screws (K). (Figure 2)
3. Attach the Large Face Plate (item #1), with the
remaining six (6) M6 x 20 flat head screws (K). Tighten
all of the flat head screws now with a 5mm hex/Allen
key (Figure 3).
4. Locate the Horizontal Material Bar (item
#5), and slide it over and through the
Vertical Track Assembly from right to left,
as shown (Figure 4).
5. Align the screw mounting holes in the
Horizontal Material Bar with the corresponding holes in the Vertical Track Assembly and
Horizontal Brace Channel. Make sure that the notched section in the Material bar is correctly
interlocked with the corresponding section of the Vertical channel (Figures 5a and 5b).
Figure 4
Figure 5a
Figure 5b