Instructions / Assembly

Table Of Contents

1 ASSEMBLY

Figure

Note: To make it easier to insert

these screws, you may back out the

squaring wedge block screw (turn

knob CCW) at the left end of the

Horizontal Material Bar beforehand

Figure 7

6. Insert the Pivot shoulder bolt (M) through the

Horizontal Material Bar and into the hole in the

Vertical Track assembly, just to the right of the

main extrusion (Figure 6). Make certain that the

shoulder of the bolt has been inserted correctly,

and then tighten securely with a 6mm hex key.

7. Insert three (3) M8 x 25 button head screws (L) with flat washers (O) into the remaining three

holes in the Horizontal Material Bar, two on the left side, and one on the right (Figure 7). Do not

completely tighten these screws yet, as they will need to be slightly loose during the squaring

procedure later.

8. With assistance, flip the assembly over so that it is now

face down on the foam packing blocks. Locate and

unpack the three lower leg sections now.

9. Pivot the left leg outward to the right (right

side of machine, facing downward) and

insert the lower left leg section (item #3), to

the main left leg (Figure 8).

ortant! Insert this Pivot bolt FIRST.

Figure

Hardware bag b