Instructions / Assembly

1 ASSEMBLY
7
10. Attach the left leg to the Horizontal Brace
Channel using two (2) M8 x 50 button head
screws (Q), flat washers (O), and lock
washers (T). Insert the screws into the
threaded holes on the rear of the channel
plate, and tighten securely with a 5mm hex
key (Figure 9).
11. Locate the right leg (left side of machine, now facing downward). Slide the right lower leg
section (item 4) into the main right leg section (Figure 10a). Assemble the right leg sections
together using one (1) M8 x 50 button head screw (Q), two (2) flat washers (O) and an M8
locknut (R). Insert the screw from the underside (front) through the bottom most hole in the leg
assembly, as shown in Figure 10b. Tighten the screw and locknut securely with a 5mm hex key
and 13mm or adjustable wrench.
12. Align the assembled right leg with the
corresponding elongated hole in the Horizontal
Material Bar. Insert the long M8 x 110 socket
head screw (V) from the underside and through
the Horizontal material bar. Slide the square
spacer (N) over the screw, and then insert the
screw through uppermost hole in the main
section of the right leg (Figure 11). Secure this
screw with one (1) flat washer (O) at each end,
and an M8 locknut (R). Do not fully tighten yet.
Figure
9
Hardware bag c
Figure 11
Spacer (N)
Hardware bag b
Figure 1
0
a
Figure 1
0
b
Hardware bag
d