Instructions / Assembly

1 ASSEMBLY
8
13. Place the Horizontal Brace (item 6)
spanning across the left and right leg
sections, aligned with the leg
mounting holes at each end (Figure
13a). Insert an M8 x 80 socket head
screw (U) with flat washer (O) from
the underside and through each leg
and the corresponding hole at the
each end of the Horizontal Brace.
Use a flat washer (O) and a locknut
(R) with each screw. Tighten both
fasteners securely now. (Figures 13b and c).
14. Assemble the Center Adjustable leg (item #2) to the bottom of the Vertical Channel Assembly.
Insert two M10 x 50 hex bolts (C), two flat washers (E) each, and one M10 locknut (D) as shown
in Figures 14a and b. Align the center leg and tighten the nuts and bolts securely with two 17mm
wrenches.
Figure 13a
See detail:
Fig. 13b
See detail:
Fig. 13c
Figure 13b
Figure 13c
Right leg assembly to Horizontal Brace
Left leg assembly to Horizontal Brace
Hardware bag e
Figure 14b
Figure 14a
Hardware bag f