Instructions / Assembly

1 ASSEMBLY
9
15. Fold the lower rear center leg and
supports up and away from the Vertical
Track Assembly (Fig. 15a). Pivot the upper
center leg section rearward, align its
bottom end with the upper end of the
lower section, and insert the lower section
into the upper one (Figure 15b). Insert two
M8 x 70 button head screws (S), one flat
washer (O) at each end, and one locknut
(R). Tighten both securely with a 5mm hex
key and 13mm wrench (Figure 15c).
16. Insert the two (2) M10 x 25 hex head bolts
(A) with M10 sleeves (B) through the U-
shaped slots the top of the Rear leg bracket
and into the Vertical track extrusion (Figure
16). It may be necessary to slightly loosen
the existing M10 hex bolts that attach the
center leg to the top of the Vertical Track
Assembly in order to properly insert these
M10 bolts and sleeves. Tighten these bolts
securely with a 17mm wrench or socket.
Figure 15a
Figure 1
6
Loosen slightly
Sleeve (B)
Figure 15b
Figure 15c
Hardware bag g